Planting a flag

Finally got this flag to print after a couple of tries. I’ve had success printing white ABS in tall vertical columns, but not so with black. I ended up printing the pole horizontally after a couple of amusing failures.

It’s a 3-piece model. Five seconds with a razor knife got everything to fit together just fine.

ReplicatorG Settings:

HBP: 120° C
1.8mm Black ABS
Using Raft
Layer Height: .25
Number of shells: 1
Feedrate: 30 mm/sec
Travel Feedrate: 55

ImageImageImage

2 thoughts on “Planting a flag

  1. Pingback: zheng3

What do you think?