Seej Pillar

My Seej fortifications have been looking a little mundane lately so I designed this seven-piece fluted column to add a little bit of architectural elegance to my battles. It handily interlocks with existing Seej bloxen, and collapses spectacularly when hit with a penny from a Seej engine.

It’s pictured here with a Riveted Bloxen for scale.

This post was originally going to be about how to adjust your gCode by hand-tweaking it to get a good raftless PLA print, but then I went ahead and downloaded ReplicatorG 037. Editing gCode wasn’t necessary, except to set the HBP temperature to 65°.

Perfect print the first time out, even with a relatively complicated model like this one. No hocus-pocus required.

1.75mm Blue PLA (available at Amazon)
Infill 10%
Layer Height .20mm
Shells: 1
Feedrate 25mm/s
Travel Feedrate 55mm/s
Print Temperature 190°
HBP Temperature: 65°

Download it here.

What do you think?