Our most recent Kickstarter was a smashing success! We were 119% funded with 140 backers. Watch this space for a comparison/post-mortem describing the differences in funding among the several Kickstarters we’ve launched, successful and not so much. I learned a great deal with Strongholds and I’m eager to apply the new knowledge and analytics to the next crowdfunding effort.
Here at Zheng Labs we’re ramping up to start the print-a-thon for backer reward fulfillment, but we have a little side project to get out of the way first. Scoundrels that we are, we’re using the slow trickle of backer survey returns as an excuse to not engage with the following print ticket:
That’s-a-lotta-printing, my friends. We’ll get started this evening, I promise.
The Easter Bunny was kind enough to drop off a roll of NinjaFlex last week, so before the printer gets ocupado producing Citadels and Eyries for the forseeable future we thought we’d give flexible filament a try.
Loading NinjaFlex into an extruder can be like shooting pool with a rope. I found that my venerable Replicator1 sucked the NinjaFlex right in without issues, but the faster G2 extruder on the Series 1 caused the NinjaFlex to bind up, thusly:
The trick is not to use OctoPrint’s Extrude button to pull the filament into the extruder– it pulls the filament in too fast, the filament backs up inside the nozzle and then starts folding upon itself and turning into silly string.
Instead, just heat up to 240°, push the lever on the side of the extruder, and manually push the filament in until you feel it hit the bottom of the nozzle. Make sure you’ve got good thermal conductivity between your hot end and nozzle too; a liberal application of thermal paste will be quite helpful.
Thermal paste fixes so many 3D printing problems.
Print settings: I’m at 240°, printing at 20mm/sec with .2 layer height. Retraction at 50mm/sec with a distance of 2mm.
Rex turned out nicely, printed on glass with Elmers’ glue stick. Then I mushed him under some PT weights.
In other gnus: there will be a lot of human downtime while I’m printing all those Citadels and Eyries, so I’ve started modeling work on the Next Thing. Here’s a peek.
#staytuned. This project’s going to be buckets o’ fun.